Skip to content Skip to sidebar Skip to footer

Exploring Bridge Configuration On MikroTik Routers

When it comes to setting up a Mikrotik router, one of the most important steps is configuring a static IP. This ensures that your network devices always have the same IP address, making it easier to manage and troubleshoot your network. In this guide, we'll walk you through the process of configuring a static IP on your Mikrotik router using the terminal.

Mikrotik Router

Step 1: Logging in to the Mikrotik router

The first step is to log in to your Mikrotik router using your preferred terminal software. You can use SSH, Telnet, or a serial console, depending on your preference. Once you've logged in, you should see the command prompt.

Step 2: Configuring your WAN interface

The next step is to configure your WAN interface to use a static IP address. To do this, enter the following command:

/ip address add address=192.168.1.10/24 interface=ether1

In this command, "192.168.1.10" is the IP address you want to assign to your WAN interface, and "ether1" is the name of your WAN interface. Make sure to replace these values with your own IP address and interface name.

Step 3: Configuring your LAN interface

Now that you've configured your WAN interface, it's time to configure your LAN interface. To do this, enter the following command:

/ip address add address=192.168.2.1/24 interface=ether2

In this command, "192.168.2.1" is the IP address you want to assign to your LAN interface, and "ether2" is the name of your LAN interface. Make sure to replace these values with your own IP address and interface name.

Step 4: Configuring your DNS servers

The next step is to configure your DNS servers. To do this, enter the following command:

/ip dns set servers=8.8.8.8,8.8.4.4

In this command, "8.8.8.8" and "8.8.4.4" are the IP addresses of your DNS servers. Make sure to replace these values with your own DNS server addresses.

Step 5: Configuring your default gateway

The final step is to configure your default gateway. To do this, enter the following command:

/ip route add gateway=192.168.1.1

In this command, "192.168.1.1" is the IP address of your router's default gateway. Make sure to replace this value with your own router's default gateway address.

That's it! You've now successfully configured a static IP on your Mikrotik router using the terminal. Remember to save your configuration changes.

Static IP configuration is an important step in setting up a Mikrotik router. By following these steps, you can ensure that your network devices always have the same IP address, making it easier to manage and troubleshoot your network. If you have any questions or need further assistance, don't hesitate to reach out to a professional IT service provider.

Mikrotik Routers PPPOE Server Configuration Over Cisco VLAN setup
mikrotik vlan benisnous cisco pppoe routers


Knowledge Area: Mikrotik Bridge Configuration Step by Step


Mikrotik Router Bridge Setup - YouTube
mikrotik bridge


Static IP Configuration on Mikrotik ( Terminal)
configuration mikrotik



Post a Comment for "Exploring Bridge Configuration On MikroTik Routers"