Exploring MikroTik RouterOS Firewall Policies For VPN

Are you looking to establish a secure IPsec VPN between your Mikrotik(RouterOS v6.47) and Vigor Router? Well, with the help of DrayTek, it is possible. In this post, we will guide you through the process step by step.

IPsec VPN between Mikrotik(RouterOS v6.47) and Vigor Router

What is an IPsec VPN?

IPsec (Internet Protocol Security) VPN is a secure communication tunnel protocol that allows you to connect to a remote network securely. It provides a secure connection by encrypting the data between the two networks that are connected, ensuring that there is no unauthorized access.

Step by Step guide to establish an IPsec VPN between Mikrotik RouterOS v6.47 and Vigor Router:

Step 1: Configuring the Vigor Router

First, you need to log into your Vigor Router's web interface. Go to VPN and Remote Access, then click on IPsec General Setup. Once you are there, configure the following:

Protocol: Select IKE with IPsec
ID Type: Choose IP Address
ID Data: Enter the WAN IP address of the Vigor Router
Pre-shared Key: Enter a pre-shared key for authentication
NAT Traversal: Enable NAT traversal

Next, click on Save.

Step 2: Configuring the Mikrotik RouterOS v6.47

Now, you need to log into your Mikrotik RouterOS v6.47 web interface and go to IP > IPsec. Click on the Add button to add a new IPsec policy.

Configure the following:

General Tab:
- Name: Enter a name for the policy
- Local Address: Enter the WAN IP address of the Mikrotik Router
- Remote Address: Enter the WAN IP address of the Vigor Router
Proposal Tab:
- Encryption Algorithm: Select AES with 128-bit key
- Hash Algorithm: Select SHA1
- Authentication Method: Select Pre-Shared Key
- Pre-Shared Key: Enter the Pre-Shared Key that you configured on your Vigor Router

Now, click on OK to save the policy.

Step 3: Testing the Connection

Once you have configured both routers, you need to test the connection to ensure that the VPN is working correctly. You can do this by pinging a device on the remote network from your local network.

To do this, open a Command Prompt on your local computer and type the following command:

ping [remote-network-device-ip]

If the ping is successful, then the IPsec VPN connection is set up correctly.

Conclusion

Establishing an IPsec VPN between a Mikrotik RouterOS v6.47 and a Vigor Router might seem complicated at first, but by following the above step-by-step guide, you can do it with ease. With the help of DrayTek, you can ensure that your VPN connection is secure and your data is protected.

Read also

So, what are you waiting for? Follow these steps and enjoy a secure connection between your Mikrotik RouterOS v6.47 and Vigor Router.